Description
The ESP32-C3 Super Mini Development Board is a compact and powerful development board designed for IoT applications, wireless communication, smart home automation, and embedded electronics projects.
Powered by the ESP32-C3 32-bit RISC-V microcontroller, this board supports 2.4GHz Wi-Fi and Bluetooth Low Energy (BLE), making it suitable for wireless monitoring, sensor networks, and connected devices.
Its small form factor makes it ideal for space-constrained projects. This version comes with unsoldered headers, allowing users to solder the pins according to their project requirements and preferred mounting method.
The board can be programmed using the Arduino IDE, ESP-IDF, and other supported development environments.
Key Features
- Powered by ESP32-C3 32-bit RISC-V microcontroller
- Built-in 2.4GHz Wi-Fi connectivity
- Bluetooth Low Energy (BLE) support
- Compact Super Mini design
- Unsoldered headers for flexible installation
- Supports Arduino IDE and ESP-IDF development
- GPIO pins for connecting sensors and electronic modules
- Low-power wireless IoT applications
- USB interface for programming and power, depending on board revision
Technical Specifications
| Specification | Details |
|---|---|
| Product Type | Wireless Development Board |
| Microcontroller | ESP32-C3 |
| Processor Architecture | 32-bit RISC-V |
| CPU Frequency | Up to 160 MHz |
| Wi-Fi | 2.4GHz IEEE 802.11 b/g/n |
| Bluetooth | Bluetooth 5 LE |
| Operating Logic Voltage | 3.3V |
| Flash Memory | Depends on board version; commonly 4MB |
| GPIO | Available GPIO pins depend on board revision |
| Programming Interface | USB, depending on board revision |
| Development Platforms | Arduino IDE, ESP-IDF |
| Header Type | Unsoldered headers |
| Board Size | Compact Super Mini form factor |
Applications
- IoT and wireless sensor networks
- Smart home automation
- Wireless monitoring systems
- Wi-Fi-controlled robotics
- Bluetooth Low Energy projects
- Smart agriculture and irrigation systems
- Environmental monitoring
- Wearable and compact electronics
- DIY embedded system projects
Important Notes
- This version comes with unsoldered headers. Soldering is required if you want to use the supplied header pins.
- ESP32-C3 GPIO pins operate at 3.3V logic. Never apply 5V directly to GPIO pins.
- Check the exact pinout and USB interface of your board revision before connecting components.
- GPIO availability and flash capacity may vary between board versions.
- Use a stable and suitable USB power source.
- This board supports Bluetooth Low Energy (BLE), not Bluetooth Classic.
Note: Board layout, USB connector, flash capacity, and pin configuration may vary depending on the manufacturer and revision.
Reviews
There are no reviews yet.